Black Generation Mode & GCR options

The Mode chooser allows to globally set the separation method used. The following options are available:

  • Auto selects a medium strong GCR method depending on the measurement data.
  • UCR: you may define the Black Start and the Black Width
  • GCR: additionally allows to define the GCR Amount
  • MinK: uses black only a little and leads to a separation using the maximum amount of CMY
  • MaxK: uses the maximum amount of black possible leading to a separation with very little CMY amounts.

 

The GCR options include settings for GCR Amount, Black Start and the Black Width:

  • GCR Amount defines how much CMY parts are replaced with black. With 0 a very light GCR is used that many affects shadow areas. 100 however uses a strong GCR which uses black from light to dark color areas.
  • Black Start defines the starting point to generate black. If the minimum of C,M,Y exceed the limit, black will be generated.
  • Black Width defines the range outside the neutral area to generate black. The lower the value the less black will be generated ouside the neutral area.

 

This entry was posted in Black Generation settings, CoPrA4, Printer Profiling. Bookmark the permalink. Trackbacks are closed, but you can post a comment.

Post a comment and download files

You must be logged in to post a comment and/or to download files.